T8 LED Lamp Fixture Bracket Kits for Single-End Powered

Energy consumption is a significant component of your company's operating expense. Engineered Products Company (EPCO) offers a wide variety of Fixture Bracket RetroFit Conversion Kits to address the Building Owner's and Facility Manager's various needs for lighting system upgrades.

We convert older T12 or T8 fluorescent lamps using magnetic ballast to strip-type fixtures using T8 LEDs.

Our low cost Fixture Bracket RetroFit Conversion Kits take into account budget, operating environment, required lumen output, energy saving goals, minimum efficacy requirements for utility rebates, and other parameters to ensure we deliver the optimal lighting system solution.

We offer Fixture Bracket RetroFit Conversion Kits for energy efficient bi-pin T8 LED in two configurations:

  • Standard - Fixture Bracket RetroFit Conversion Kits (4-foot and 8-foot lengths).
  • Pre-wired - Fixture Bracket RetroFit Conversion Kits (4-foot and 8-foot lengths); includes supply line and luminaire disconnect.

These kits are specifically intended for use with Type B single-ended powered bi-pin T8 LED Lamps classified to UL Standard 1598.

Our Fixture Bracket RetroFit Conversion Kits mean your upgraded lighting system will:

  • Consume 30% less energy.
  • Easily integrate with automatic lighting controls and occupancy sensors.
  • Improve the look and feel of your environment.

BENEFITS FOR THE BUILDING OWNER AND FACILITY MANAGER

  • Retrofitting takes half the time and half the cost compared to installing a new lighting system.
  • Expedites installation time by 25%!
  • Simple upgrade to energy efficient lighting.
  • Initial energy savings up to 40% or more.
  • Payback periods from 15 months to 3 years for most installations.
  • Sustainable ongoing energy savings.
  • The original fixture housing is reused.
  • Minimal rewiring and recycling on the job site.

NOTE:

  1. P/Ns: 14070, 14070B, 14071, and 14076 require a Type "B" Single-End Powered Bi-Pin T8 LED Tube; classified to UL Standard 1598C. These part numbers also require the incoming line voltage be connected to the "single" powered end of the T8 LED Tube.
  2. For Pre-Wired Part Numbers 14073, 14073B, 14074 and 14074B the incoming line supply voltage must be connected to the "HOT" and "Neutral" (Black and White) conductors on the wiring harness luminaire disconnect.
  3. Part Numbers 14070B, 14073B, 14074B, and 14080 must be ordered in quantities of twenty (20).