• Meets the requirements of the 2023 National Electrical Code: Articles 348.20 (A)(2)(5), 348.22, 410.117 (A, B, and (C), and 410.137 (C), 517.12, 517.13 (A).
• Significant Contractor time and labor savings!
• Pre-attached connectors add speed and dependability when finalizing fixture whip terminations.
  • WAGO® Push wire 4-port connectors on each end of the QuikWhip.
  • Two (2) Die Cast "Snap-In" Connectors on each end of the QuikWhip. Snaps directly into the fixture housing.
• No tools required to install the QuikWhip! A cost-effective solution that eliminates lock nuts and wire nuts.
• Easily insert the fixture's conductors into the corresponding ports on the WAGO connector and you're finished. No wire nuts to twist or taping required.
• Average Time Savings: 45% or up to three (3) minutes per fixture installation.
• Approximate “installed” cost savings per fixture: $2.00 - $3.00.
• Solid or Stranded THHN Conductors enclosed in 6-feet of 3/8" (.375") Flexible Steel Conduit - Standard.

When you add-up your time and material cost, it makes economic sense to buy "pre-fabricated", ready-to-install QuikWhips from Engineered Products Company.

NOTE: The ground bonding conductor on each end of the QuikWhip includes a "green" WAGO grounding conductor.

QuikWhip Fixture Whips Part Number Reference Example:  E P W 1 8 6 4  A D P 2 - H N G

18 = Wire Gauge; 6 = Length (in feet); 4 = Wires; AD = Die Cast Snap-In Connector; P = Push Wire Style Connector; 2 = Each End. WAGO connectors will be pre-attached to each end of the Quikwhip on the HOT, Neutral and Ground wires. HNG = Hot/Neutral/Ground

© The WAGO connector is a registered trademark of the WAGO Corporation, Germantown, Wisconsin.

Find out Why Contractors Use EPCO Fixture Whips »